Registering and Updating Firmware
Download Barbieri Gateway and register the device.
Check for the latest firmware, which is self-explanatory through the software. It automatically recognizes unregistered devices upon connection
Preparing for Measurements
Before inserting the target sheet for measurement, ensure to cut off excess material according to dotted cut marks
Ensure the target sheet is straight and flat to fit into the device.
Setting Up in Calibrator
Type: Barbieri Spectro Swing qb
Connecting measurement device to be used for profiling / recalibration:
TCP IP connection:
Insert IP Address in the preferences. To set a static address for the Barbieri see the document linked to this article.
USB connection:
Connect devices directly through USB cable
Measure Aperture automatically adapts to ratio of Patch Size, when the patch size is smaller or equal to 6mm, then 2mm aperture is applied
Pre-Measurement Maintenance
For replacing the measuring lamps or clearing a paper jam, it is necessary to open the upper cover of the instrument
It is also recommended to open the cover for cleaning the optics every now and then open the instrument
Switch off the device and disconnect the power supply
Release the upper cover by unscrewing the screws situated on the left and right side of the instrument and carefully remove the cover
Storage
Make sure to use the black fabric cover to put over the device when it is not in use. It prevents dust gathering in the device