Durst: Hotfolder not found

Durst: Hotfolder not found

Durst drivers allow for various output hotfolders, which can be set in the PMM and is available in e.g. Layout to change. 



The hotfolders are created by the Durst DFE and therefore, the output path in the RIP driver needs to be set to the hotfolders folder on the DFE to allow the hotfolder number option in the driver to work.

  1. In RIP:   E.g.: Y://Hotfolders  (map to root on DFE)
  2. On the Durst DFE it will be mnt/images
  3. In Calibrator you select Hotfolder number: 0 stays in the same Hotfolder root folder
    1. -> 1 -> will rip to  Hotfolders/Hotfolder01
-  If in RIP driver you map it to one of the hotfolders
  -> e.g. Hotfolders/Hotfolder01 directly:  You cannot select the hotfolder nr in Calibrator

Warning
Note:  If RIP driver is mapped to a local folder, no hotfolder numbers can be as those folder are not created and thus not found. 






    • Related Articles

    • Hotfolder input Component

      Supported file types pdf, tif, eps, jpg, png and aur are supported file types. The Hotfolder also support PrintFactory format xml's. This means that xml's that start with /Job and /NestParts, they are supported because of legacy created xml's for ...

    • Durst Linux Integration

      Hotfolders When selecting the hotfolder in printfactory RIP, you can select the "Hotfolders" folder and within the PMMs you can choose a numbered folder that you would like to send the output to depending on the PMM. If you send a job, and you do not ...

    • ROOM Hotfolder conflict

      If you set a ROOM connection for your printer, you should not use a folder that is set as a Hotfolder of a queue (each queue has a Hotfolder set into queue settings > Workflow). If the ROOM queue and a Hotfolder are pointing to the same ...

    • Auto-disable not found spot colors

      What For packaging proofs the technical channels like die-lines, varnish etc must be disabled (not-show, not-print) automatically. Only leaving process and recognised spot colors enabled. Available from V6.7.0 onwards Where to find 1. Editor: ...

    • Kornit DTG set-up

      Kornit DTG printers uses a dynamic configuration system based on KST files. Those files define the resolutions, media properties and all handling settings that are available in the DFE of the printer. At the printer a the PrintAgent needs to be ...