The DYSS driver in PrintFactory assumes a specific tool set-up. When the current ground table in the Kasemake software (which drives the DYSS) is not matching the defined set-up the operator needs to remap the tools.
For the convenience of the operator it is recommended to set-up the ground table in the Kasemake software:
Kornit DTG printers uses a dynamic configuration system based on KST files. Those files define the resolutions, media properties and all handling settings that are available in the DFE of the printer. At the printer a the PrintAgent needs to be ...
How to setup a cross-cable peer-to-peer mini-network between the computer and the printer. First of all, connect physically a crossover cable to the network connectors of both the computer and the printer. On the printer: Set the Ip 192.168.100.1 and ...
The steps below describe how to set up the Summa so that the cut jobs in the RIP are picked up automatically by reading the barcode. File preparation - Layout: Create a print and Cut file using e.g. Summa S Class 2 160 D/T - Select the Summa S Class ...
In Layout the flatbed printers have their default origin or 0,0 point, bottom right. When printing double sided: in case of Opaque with Turn, the A-side is flipped and the 0,0 point is thus moved to left bottom so the 0,0 point of the B-side falls on ...
Connecting VUTEk printers usually run a LINUX version on their DFE with a folder \INCOMING\ already shared (if no share is yet created, check the DURST install instructions for sharing folders on a UNIX system or check with local IT; more info might ...