Related Articles
Fotoba - Layout Component
Fotoba Marks Tool The Fotoba Marks tool adds Fotoba registration marks and barcodes to printed jobs. These marks are read by Fotoba cutters to automatically align, trim, and finish media without manual setup. It supports the Fotoba V2 barcode system ...
Fotoba Version 2
The following changes and additions are made to the Fotoba system compared to v1 of the Fotoba system: Fotoba definition is fully customisable. In v1 only the bar width and spacing could be defined. Fotoba definitions can be stored in the Fotoba ...
Fotoba XY cutter – Sensor guide
Fotoba XY cutters have a sensor guide. The sensor guide allows the vertical cutter blades to adjust to any distortion in the print or deformation of the media. The option adds an additional continuous vertical line for X/Y cutters equipped with a ...
Summa set-up for Barcode reading
The steps below describe how to set up the Summa so that the cut jobs in the RIP are picked up automatically by reading the barcode. File preparation - Layout: Create a print and Cut file using e.g. Summa S Class 2 160 D/T - Select the Summa S Class ...
Summa Cutter OPOS Barcode
What? PrintFactory supports the use of the Summa OPOS Barcode. There’s a built-in Summa Barcode server embedded in our software which is in use if the cutter is connected directly to the RIP by USB or TCP/IP. When a print & cut job is created (See ...