Fotoba XY cutter – Sensor guide

Fotoba XY cutters have a sensor guide. The sensor guide allows the vertical cutter blades to adjust to any distortion in the print or deformation of the media.

The option adds an additional continuous vertical line for X/Y cutters equipped with a sensor. 

Where: Layout -> Cutter -> Fotoba XY automatic

• Related Articles

• Fotoba Version 2

  The following changes and additions are made to the Fotoba system compared to v1 of the Fotoba system: Fotoba definition is fully customisable. In v1 only the bar width and spacing could be defined. Fotoba definitions can be stored in the Fotoba ...

• Roland Cutter Setting adjustment

  This article provides a quick guide on how to adjust the settings on your Roland cutter to ensure that the coordinate system works optimally. By default, the home position is set on the left side of the cutter. However, for better alignment with the ...

• Fotoba - Layout Component

  Fotoba Marks Tool The Fotoba Marks tool adds Fotoba registration marks and barcodes to printed jobs. These marks are read by Fotoba cutters to automatically align, trim, and finish media without manual setup. It supports the Fotoba V2 barcode system ...

• Summa Cutter OPOS Barcode

  What? PrintFactory supports the use of the Summa OPOS Barcode. There’s a built-in Summa Barcode server embedded in our software which is in use if the cutter is connected directly to the RIP by USB or TCP/IP. When a print & cut job is created (See ...

• Setting up a Colex Cutter with Colex SharpCut.

  Setting Up a Colex Cutter in PrintFactory When configuring a Colex Sharpcut cutter with PrintFactory, there are two common setup issues that can prevent successful output. This guide walks you through how to resolve both. 1. Port Number Configuration ...