Print a purely linear file

Print a purely linear file

This process allows any compatible file to be output from the linear settings of a profile. This is processed from Calibrator.

Select Printer

Select Mode

Click Print button

This launches the finder window to select the file required, then the file needs to be aligned to the media. The file will then go through the RIP to be available on the device for output.


    • Related Articles

    • Alignment and Nesting: Print Bottom first

      What When Print Bottom first is enabled the print Job is rotated 180degr. and thus will start printing from the bottom of the job. This is used when printing on roll and the roll is cut afterwards, whereby the end of the print job will now be the ...

    • ‘Print mode not supported’ on HP printers

      Why This message could have 2 reasons, either: a certain print mode built for a certain printer has been changed or deleted. Consequently, the mode does not match up with the profile used a certain print mode has been updated via HP firmware or ...

    • Océ Colorado 1640: managing media and print mode settings

      Océ have decided upon an architecture where the print and media settings are stored in the printer profile. Consequently, any changes to these settings require changing the pmm. This document describes how media and print settings are changed once ...

    • PrintAgent Support for DFE’s

      PrintAgent (PA) is a service that can be installed on Windows or Linux operating systems on the DFE of a printer or cutter. It functions as a local application, allowing remote RIPs to access local files on the DFE and spool files to the local hard ...

    • Print from MacOS X to Virtual Printer on Windows

      On Win, create your queue into RIP and make sure you checked “Register as a printer” option into the Layout tab : Go to Windows “Start->Control Panel->Printers and Faxes” and right click on the name of the queue created at step 1. Choose “Sharing…” ...