Related Articles
Editing Paths with the Connect and Split Tool
Two end points of a path can be connected. You can use the Knife tool to split a path. How to connect two end points 1. Select the Connect tool from the Tools panel. 2. Click one point that you want to connect to the next. 3. Click the second point. ...
Edit Paths
You can use the Actions panel (Window > Actions) to manipulate points and paths. First select the path or point and then apply the action. By clicking the Shift key, you can apply the action to more than just one pair of points. Connect and split ...
HP Latex On-board Spectrophotometer
The HP Latex series offer an build-in measurement device for all supplied models. There is a difference in use and support between the small (baby) and large models (LX). Latex 200/300/L25500/L26/L500 (baby) series The build-in measurement device of ...
Textile Step and Repeat in-RIP repeated processing
What? When the ‘Split into Individual Pages’ option is switched on in Layout this will trigger In-RIP repeating and no longer render the entire job. This results in a significantly faster processing speed of Step & Repeated images. If using ...
Flatbed tiling with overlap in Editor
What This document shows how to set up tiling with overlaps for flatbed printing in Editor. This is not available in Layout. How Open Editor Open image Set the total dimensions of the job/ Output Select Finishing tool – Apply Bleed all round in ...