Summa S2 OPOS-Cam

Summa S2 OPOS-Cam

The Summa S2 OPOS-CAM model requires the use of the Summa Cutter Control software, it cannot be driven directly from the PrintFactory RIP unlike the OPOS sensor models. This is because it has a camera instead of a sensor to read the marks and barcode. The camera feed is sent directly by USB to the Summa Software. The same driver is used for OPOS Sensor or OPOS Cam, you just need to use the folder output instead:

How?

The output folder should be the same folder that the Summa Cutter Control barcode server is searching for cut files. PrintFactory will output two cut files at 0 and 180 degrees orientation, this means the user can load the cut job into the Summa in either direction & the OPOS-CAM will read the barcode and retrieve the cut file. Tool methods and parameters should be set in the Summa Cutter Control application.

Restrictions:

  • Summa S2 with OPOS-CAM requires a USB connection, ethernet is not available.
  • Summa Cutter Control is only available for Windows OS, macOS version is not available.

In case of problems:

  • Ensure you have the latest Summa USB drivers installed, these are available on the Summa webpage.
  • Ensure you have the latest version of Summa Cutter Control.
  • Ensure your Summa Cutter firmware is up to date.
  • Disconnect other camera devices from the PC.

    • Related Articles

    • Summa set-up for Barcode reading

      The steps below describe how to set up the Summa so that the cut jobs in the RIP are picked up automatically by reading the barcode. File preparation - Layout: Create a print and Cut file using e.g. Summa S Class 2 160 D/T - Select the Summa S Class ...
    • Summa Cutter OPOS Barcode

      What? PrintFactory supports the use of the Summa OPOS Barcode. There’s a built-in Summa Barcode server embedded in our software which is in use if the cutter is connected directly to the RIP by USB or TCP/IP. When a print & cut job is created (See ...
    • Summa S Class 2 Extended load

      The Summa S Class 2 series cutters have an 'Extended Load' function. This function makes it possible to define the limits of the Y axis so that the cutter can cut outside the pinch rollers. The media needs to be loaded before this function can be ...
    • Summa Twin X

      Summa's Twin X mode is a workflow designed to enhance cutting efficiency by integrating Summa roll cutters with F Series flatbed cutters. This integration allows both machines to process the same cutting files and registration marks, optimizing ...
    • Summa Cuts offset

      Issue description: - cutter starts ok then slowly cuts offset. After the next marker dot, it is back inline Explanation: - This happens when the material is Clear, the white under the barcode is picked up as the start point. Resolution is to cover ...