SwissQprint Nyala-4: 3 and 5 layer printing - driver settings
Below is the layering in the driver setup to print 3 and 5 layers for the Nyala.
To set up the File in Layout: Double sided needs to be enabled: more info on Layout setup for multi layering
A. 3 Layer with same image Front and Back
Layering = Color / White / Color
B. 3 Layer with Different image Front and Back
Layering = Color / White / Blocker / Color
Note: The Blocker mode is not printed, only activated to allow for a different image Front and Back
Note: The Blocker mode is not printed, only activated to allow for a different image Front and Back
C. 5 Layer with Different or Same image Front and Back
Layering = Color/ White/ Blocker / White/ Color
Related Articles
5-Layer Printing
What? Certain printers support 5-layer printing modes in 1 pass by overprinting a total of 5 layers of color + white + blocker + white + color. Different images (or the same) can be shown on the front and back on a single sheet of media, all ...swissQprint Relief & Textured Printing
swissQprint UV inkjet printers are capable of impressive relief and textured printing, offering a range of capabilities that cater to the demands of various industries. These printers are recognized for their proficiency in creating layered relief ...Inca Multi Layer Printing
For the Inca OnSet S40 and Q40 multi layer printing is available in the driver. Allowing to print Color and White separately using different modes/speeds and densities for color and the white layer. Also it support Color-White-Color using several ...Continuous printing on Epson SC-R5000
There is a method to print "continuously" on the Epson SC-R5000. This means that there will be a smaller gap between the jobs and the printers cool down/warm up sequence will be skipped. The prerequisites for this are as follows: 1. Turn off job ...Variable Data Printing (VDP)
The variable data process involves a template file, in which PlaceHolders and special keywords are defined. When Variable Data is used, these PlaceHolders and keywords will be replaced. In the Editor, Variable data can be done by importing files in a ...