PrintAgent Support for DFE’s

PrintAgent Support for DFE’s

PrintAgent (PA) is a service that can be installed on Windows or Linux operating systems on the DFE of a printer or cutter.  It functions as a local application, allowing remote RIPs to access local files on the DFE and spool files to the local hard drive without setting up sharing and access rights.   PrintAgent feeds back to the RIP: 
  • Job status
  • Copy count
  • Ink and media consumption – depending on the printer

PrintAgent enables for the SwissQPrint drivers additional features: more info here

There is also a lightweight version of PrintAgent that is used for Job Status Tracking only.

Below is a list of printers and cutters that use PrintAgent

DevicePrintAgent
KornitRequired – Windows
Zund Cut CenterOptional for Job Tracking – Windows
SwissQPrintRequired – Windows
Durst AlphaOptional – Linux Lightweight
HP FB1x000 SeriesRequired (when RIP is not on DFE) Windows
IncaRequired – Windows
VutekOptional – Linux Lightweight

Installers

From V6.7.1 onwards, on Windows systems, the PA is part of the PrintFactory installer and can be found in c:\\Program Files\Printfactory.  

Download PA for Windows 

Download PA for Linux

Download PA for Windows (32 Bit)

Installation

Windows

The process for Windows is fairly straightforward:

  1. Move the installer to the desktop of the Printer or Cutters Digital Front End. Make sure not to install PA on the RIP pc.
  2. Run the PA installer.
  3. Go to RIP, File -> Output device -> New and select the driver.
  4. Add the IP address of the printer/ cutter
  5. select the screen icon left of the and then browse to the folder you wish the output fils to go to.
 

Linux

Below are the steps written out and here is a video
  1. Copy the downloaded PrintAgent.py file on the Desktop directory of the Linux DFE.
    Note: the installer will be automatically removed once installation is complete. Make copy if desired.
  2. Create a PrintAgent directory at the home location (path would be .e.g /home/vutek01)

  3. Open Terminal app
  4. Type: cd Desktop and click enter
  5. type: sudo python PrintAgent.py and click Enter

  6. type : Yes (to accept license) and click Enter
  7. Type /home/vutek01/PrintAgent and click Enter


To change the settings it is easiest to uninstall the PrintAgent  install PrintAgent again.


    • Related Articles

    • PrintAgent: installed on RIP prevents comms between RIP and Cal

      If PrintAgent is installed on the RIP pc instead of the DFE, then the Calibrator can not detect the printers in the RIP. Print Agent needs to be installed on the DFE pc.

    • ‘Print mode not supported’ on HP printers

      Why This message could have 2 reasons, either: a certain print mode built for a certain printer has been changed or deleted. Consequently, the mode does not match up with the profile used a certain print mode has been updated via HP firmware or ...

    • Installing an HP Scitex 15000: Driver Selection Guide

      When setting up an HP Scitex 15000, it's crucial to select the correct driver for seamless integration with PrintFactory RIP. Here’s what you need to know: 1. Setting Up PrintAgent The HP Scitex 15000 requires the use of PrintAgent. Before ...

    • Alignment and Nesting: Print Bottom first

      What When Print Bottom first is enabled the print Job is rotated 180degr. and thus will start printing from the bottom of the job. This is used when printing on roll and the roll is cut afterwards, whereby the end of the print job will now be the ...

    • Roland decoupled Print & Cut

      This document is written to clarify the working of Roland Registration Markers and to give some hints what could be wrong in some cases. Introduction First of all we will show you a snap of the Output Inspector so it will be clear what to expect when ...